Zebra Stripe Technical Information download pdf (Page 77)

1. Turn the printer OFF and remove the power cord.

2. Refer to Ribbon/Media Supply and Drive System drawings in Section 7.

3. Remove the Rear Cover, Front Control Panel Assembly, Media Sensor

Assembly, and Main Logic Board. See previous procedure if necessary.

4. Loosen two (2) 1.5mm Hex screws and slide the Bevel Gear (44046-2) from

the Ribbon Take-Up Spindle Shaft.

5. Remove two (2) 5mm Hex screws holding Ribbon Tension Motor Assembly

and mounting bracket to the Main Frame.

6. Install the new Ribbon Tension Motor Assembly with bracket using the two

(2) 5mm Hex screws.

7. Slide the Bevel Gear back on and retighten to shaft.

8. Reinstall the Main Logic Board, Media Sensor Assembly, Front Control

Panel Assembly and Rear Cover.

9. Perform the Ribbon Take-Up Spindle Tension Adjustment on page 5-27.

1. Turn the printer OFF and remove the power cord.

2. Refer to the Drive System Drawing in Section 7.

3. Remove the Rear Cover, Front Control Panel Assembly, Media Sensor

Assembly and Main Logic Board. See previous procedures if necessary.

4. Loosen the fastener for the Idler Pulley and remove the Main Drive Belt.

5. Remove the screw holding the Stepper Motor (if present).

6. Disconnect the Stepper Motor Cable from the Power Supply.

7. Carefully grasping the Stepper Motor, turn it counter-clockwise and remove

from slots.

8. Reverse the procedures in steps 1 through 7 to install the new motor.

9. Adjust the tension on the Main Drive Belt as explained in the instructions

on Page 5-35 (Standard Printer) or 5-36 (Printer with Peel-Off Option.)

10. Proceed to the Motor Balance Procedure.

Page 5-38 44868L

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 118 119

No comments

Zebra Stripe Technical Information Page 77