Zebra Stripe Technical Information download pdf (Page 44)

NOTE: Make the Media Sensor Sensitivity and Ribbon Sensor Sensitivity Adjustments

at the same time.

1. Remove the Electronics Cover to allow access to the Main Logic Board.

2. For media with backing material: remove several labels from the media

backing and load just the backing into the printer then close the printhead.

For notched tagstock: remove media completely and calibrate on air.

3. Press the Pause, Feed, and Cancel Keys all together and hold while turning

the printer ON. (Do not turn power OFF until Step 11.)

4. Insert a non-metallic potentiometer-adjusting tool through the hole labeled

MEDIA in the Main Logic Board.

5. Adjust the potentiometer until the Darken light and Position light are both

ON and visually look the same brightness. See Figure 5.3.

6. Remove the ribbon from the printer. Ensure the printhead is closed.

7. Insert the potentiometer-adjuster through the hole labeled RIBBON.

8. Adjust the potentiometer until the Printhead and Paper/Ribbon lights are

both ON and visually look the same brightness. See Figure 5.3.

9. Replace the Electronics Cover and reload ribbon and media.

10. Press the MODE key to print Media and Ribbon Sensor Profiles for reference.

11. After the profiles are printed, cycle power OFF then ON to resume printing.

NOTE: If the printer goes into PAUSE mode and the Paper/Ribbon light comes ON, you

may need to perform the Supplemental Media Sensor Sensitivity Adjustment

Procedure on the next page.

44868L Page 5-5

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 118 119

No comments

Zebra Stripe Technical Information Page 44