Zebra Stripe Technical Information download pdf (Page 70)

1. Refer to the Cover Assembly Drawing in Section 7 and remove the Front

Door (part # 44076) of the printer.

2. Remove the Printer’s Electronics Cover and refer to the Control Panel

Drawing part # 44072 in Section 7.

3. Remove the 5mm Hex screw that attaches the Control Panel Assembly to the

Main Frame.

4. Detach the Control Panel Ribbon Cable from the Main Logic Board. Note

the position of the Ferrite Core on the cable.

5. Grasp the Control Panel Assembly by its sides and carefully lift it out of the

printer base guide slots.

NOTE: On certain printer models removal of the Control Panel Assembly allows visual

inspection of the alignment of the Main Logic Board and the Media/Ribbon

Sensor Assembly connection.

1. Detach the Control Panel Board from the Control Panel Cover, by removing

the two (2) 5mm Hex mounting screws.

2. Carefully align the replacement board over the mounting holes on the

Control Panel Cover and reinstall the two (2) 5mm Hex screws. Torque

screws to 6 inch-pounds.

3. Remount the Control Panel Assembly in the base guide slots and secure into

the Main Frame by reinstalling the 5mm Hex screw.

4. Reattach the Control Panel Ribbon Cable to the Main Logic Board. Insure

the Ferrite Core is positioned properly.

5. Remount the Printer’s Electronics Cover and the Front Door

44868L Page 5-31

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 118 119

No comments

Zebra Stripe Technical Information Page 70