Zebra Stripe Technical Information download pdf (Page 82)

Troubleshooting Tables........................................................................6-1

Sample Labels for Troubleshooting ..................................................6-5

Factory Assistance ............................................................................. 6-10

Returning Equipment................................................................. 6-10

Consult the following Troubleshooting Tables and compare the printer output to

the sample labels provided on the following pages to improve the quality of your

labels.

All lights never light. No AC Power applied to the

Printer.

Insure that the AC Power Cable is

connected to a working voltage source.

Faulty AC Power Fuse. Replace Fuse.

No voltage available from the

internal Power Supply.

Replace Power Supply.

All lights turn ON

and stay ON, or all

lights (except

POWER Light)

never turn ON.

Main Logic Board or EPROM

faulty or loose interconnecting

cables.

Insure cables are properly connected,

EPROMs are properly installed or replace

the Main Logic Board.

CALIBRATE Light

turns OFF after 5 sec

but all other lights

stay ON.

Main Logic Board Dynamic

RAM failed.

Replace Main Logic Board.

CALIBRATE Light

and POSITION

Light OFF but all

other lights ON.

FONT ROM error. Replace Font ROM.

All lights Flash ON

and OFF.

No significant amount of

DRAM tested good.

Replace Main Logic Board.

All lights (except

POWER Light) are

OFF and no printer

operation possible.

Printer misconfigured for

Peel-Off Mode and Peel-Off

Option not installed.

If Peel-Off Option is installed, check Take

Label Sensor.

If Peel-Off Option is not installed, check

printer configuration and insure Peel-Off

mode is not selected.

Printer locks up

while running Power

On Self Test.

An improper configuration was

set.

Reload factory defaults. Then, set correct

parameters.

Main Logic Board failure. Replace Main Logic Board.

Printer stops.

PAPER/RIBBON

Light Flashes and

the PAUSE Light

ON.

Media not loaded or incorrectly

loaded.

Load media correctly.

Misadjusted Media Sensor. Check Media Sensor operation. Adjust if

necessary. (Run Printer Calibration).

44868L Page 6-1

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 118 119

Comments to this Manuals

No comments

Zebra Stripe Technical Information Page 82

Comments to this Manuals

Related products and manuals for Label printers Zebra Stripe