Zebra Stripe Technical Information download pdf (Page 56)

CAUTION: The Screws in the Print Mechanism are of different lengths.

Incorrect replacement could damage the Printhead. Segregate the screws

during disassembly to insure they are returned to their proper position.

4. Remove the Strip Plate “F” and set aside.

5. Remove the screw and star washer which secures the Ground Strap “E” to

the Head Mounting Bracket “B”. NOTE: This screw is longer and must be

used in the same position.

6. Remove the two Position Locking Screws “H” and washers from the Head

Mounting Bracket “B”.

7. Open the Printhead Latch and carefully pull the combined Printhead

Assembly “A”, Head Mounting Bracket “B”, and Printhead Support Bracket

“D” forward from the Head Bracket “C”, removing the Ribbon Cable “G”

from the Printhead Assembly “A” when there is sufficient clearance.

8. Remove the screws from the Printhead Support Bracket “D” and the

remaining screws securing the defective Printhead Element Assembly “A,”

noting the location of each screw to assure proper reassembly.

CAUTION: The Printhead Element Surface can be scratched and

damaged by coming in contact with any hard or abrasive objects.

9. Install the new Printhead Element Assembly “A”, making sure that it mates

properly with the mounting posts on the Head Mounting Bracket “B” before

attempting to reinstall the screws. (Leave the Printhead Support Bracket

“D” screws loose to allow for adjustment.)

10. Reinstall the assembly into the printer assuring that the Head Mounting

Bracket “B” slides under the wings of the Head Bracket “C”.

44868L Page 5-17

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 118 119

No comments

Zebra Stripe Technical Information Page 56