Zebra Stripe Technical Information download pdf (Page 35)

IV. Reassemble the Cutter Module.

1. Refer to Figure 4.6. Position the two Wire Springs down against the Lower Cutter Blade.

2. Place the Rear Cutter Blade Guard over the Wire Springs, perpendicular to its final position. Place

your thumbs on the top (flat) part of the Guard.

NOTE: Insure that the ends of the Rear Cutter Blade Guard are positioned on the outside of the

Cutter Side Panels.

3. See Figure 4.6. Press the Rear Cutter Blade Guard down and forward, rotating the Guard as you

proceed, to lock the mounting pins into position in the Cutter Side Panel mounting slots. Slide the

Guard forward until the two Wire Spring Loops pop up on the back side of the Guard.

NOTE: Insure that the Wire Springs remain positioned under the Rear Cutter Blade Guard when

assembly is completed.

4. Lower the Upper Cutter Blade Guard back to its normal position. When reassembled, the back of

the Cutter Module should look like the one shown in Figure 4.8.

This procedure is continued on page 4-8.

Page 4-6 44868L

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 118 119

No comments

Zebra Stripe Technical Information Page 35