Zebra Stripe Technical Information download pdf (Page 76)

1. Refer to the Platen and Power Supply Drawing in Section 7.

2. Remove the Rear Cover, Front Control Panel Assembly, Media Assembly,

Main Logic Board and Tear Off Plate. See previous procedures if necessary.

3. Loosen the fastener holding the Idler Pulley and remove the Main Drive Belt.

4. Disengage the Platen ground chain, remove the Platen and pivot the Platen

Bearings out of the slots.

5. Remove the Platen Pulley.

6. Install Bearings, Washers and Platen Pulley on the new Platen exactly as

found on the old one.

7. Reinstall the platen assembly by hooking the out-board bearing and

dropping the in-board bearing into its slot.

8. Re-engage the Platen ground chain.

9. Reinstall the Main Drive Belt.

10. Adjust the tension on the Main Drive Belt as explained in the instructions

on Page 5-35 (Standard Printer) or 5-36 (Printer with PEEL-OFF Option.)

11. Reinstall the Main Logic Board, Media Sensor Assembly, Tear Off Plate,

Front Control Panel Assembly and Rear Cover.

44868L Page 5-37

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 118 119

No comments

Zebra Stripe Technical Information Page 76