Zebra Stripe Technical Information download pdf (Page 84)

Poor Print Quality. Darkness too low. Increase Print Darkness.

Incorrect Media and Ribbon

combination.

Replace Media or Ribbon.

Printhead Adjustments incorrect. Perform required adjustments.

Truncated print, no

print, or FEED Key

operates incorrectly

while using

non-continuous

media.

Incorrect Media Sensor position

or sensitivity.

Adjust Media Sensor.

Label Length Parameter is set

less than the actual label length.

Set the correct label length.

Printer that is in Peel-Off mode

was powered ON without media

being properly loaded.

Load media correctly for Peel-Off mode.

Printer is not calibrating media

properly.

Perform Media Adjustments. Set value with

the “^SS” ZPL II Command.

Long tracks of

missing print on

several labels.

Wrinkled ribbon. See Wrinkled Ribbon in this Table.

Print Element damaged. Replace printhead.

Fine gray lines on

blank labels at

angles.

Wrinkled ribbon. See Wrinkled Ribbon below.

Wrinkled ribbon. Ribbon fed through machine

incorrectly.

Load ribbon correctly.

Incorrect Darkness setting. Set the Darkness to the lowest setting

possible for good print quality.

Incorrect printhead pressure,

balance, or position.

Set the pressure to the minimum needed.

See Print Quality Adjustment and Printhead

Pressure Adjustment procedures.

Incorrect Dual-Tension Spindle

setting.

Pull Spindle End-Cap out when using wide

media to obtain normal (higher) tension.

Media not feeding properly; it

is walking from side to side.

Make sure the media path remains straight

by positioning the Media Guide closer to

the media.

Strip Plate needs adjusting. Perform adjustments.

Ribbon Supply Spindle tension

needs adjusting.

Perform adjustments.

Printhead needs realigning with

platen roller.

Perform adjustments.

Ribbon Take-up Spindle tension

needs adjusting.

Perform adjustments.

Light printing or no

printing on the left

or right side of the

label.

Printhead pressure needs

balancing.

Adjust balance. See Printhead Pressure

Adjustment procedures.

Misregistration and

Skips Labels.

Misadjusted Media Sensors. Perform Media Sensor Adjustments.

Improper Spindle Tensions. Perform Spindle Adjustments.

Improper ZPL II Format. Correct the ZPL II Format.

44868L Page 6-3

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 118 119

Comments to this Manuals

No comments

Zebra Stripe Technical Information Page 84

Comments to this Manuals

Related products and manuals for Label printers Zebra Stripe