Zebra Stripe Technical Information download pdf (Page 42)

5. Press “PAUSE” to resume printing, and check the new setting.

6. For further adjustment, repeat steps 2 through 5. (When no further

corrections are required, press the “PAUSE” Key then press the “MODE”

Key three (3) times so that all MODE lights are OFF.)

7. Press “PAUSE” to resume printing, and check the new setting.

The stopping position of the media can be adjusted to achieve the desired

Tear-Off position. If adjustment is necessary, refer to the MODE Key description

in the printer’s user’s guide. The media stopping position is adjustable in

increments of four dot rows at a time. The possible adjustment range is ±80 dot

rows or a distance of 0.392″ (10mm) up or down from center. Powering down is

not required to reset this parameter. See Figure 5.1.

This illustration shows how higher values move the label further

out from the printer (moves the tear line closer to the leading

edge of the next label) while lower values move the label into the

printer (moves the tear line closer to the trailing edge of the

printed label).

44868L Page 5-3

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 118 119

No comments

Zebra Stripe Technical Information Page 42