Zebra Stripe Technical Information download pdf (Page 37)

V. Reinstall the Cutter Module.

1. Refer to Figure 4.9. Position the Cutter Module above the Cutter Mounting Posts. Press down on

the Cutter Module until the Mounting Slots engage the Mounting Posts on the printer.

2. Refer to Figure 4.3. Tighten the Mounting Screw in a clockwise direction to hold the Cutter

Module in Position.

3. Refer to Figure 4.3. Position the Cutter Cable Connector so the flat side of the connector faces

away from the printer, then insert it up into the mating connector on the Cutter Module.

4. Replace the Cutter Catch Tray onto the two mounting slots located on the front of the Cutter

Module.

VI. Test the Cutter Operation.

1. If necessary, reload ribbon and label stock into the printer, then close the printer’s Front Door and

Media Access Door.

NOTE: When loading media, make sure the end of the label is positioned on top of the Platen

Roller, then close the Printhead Latch.

2. When the printer is turned ON, the Cutter Module will cycle through one cutting operation and be

ready to print labels.

3. OPTIONAL: Hold in the PAUSE key while turning the printer’s AC power ON. When the Power

ON Self Test begins (all lights ON), release the PAUSE key. When the Power ON Self Test ends,

the printer prints test labels which the Cutter Module will cut.

End of Cutter Cleaning Procedure.

Page 4-8 44868L

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 118 119

No comments

Zebra Stripe Technical Information Page 37