Zebra Stripe Technical Information download pdf (Page 48)

6. Reload media and ribbon.

7. Perform the Printhead Voltage Adjustment found later in this section, then

return to Step 8.

8. After setting printhead voltage, run PAUSE Test labels and perform the

Printhead Adjustment Procedure as needed to achieve optimum print quality.

9. Print a series of test labels to insure continued quality printing.

10. If the Cutter Option is used, you MUST perform the Cutter Voltage

Adjustment Procedure.

A #2 Phillips screwdriver and a flathead screwdriver will be required.

I. Check the initial print quality.

1. Open the Media Compartment Door and Front Panel on the printer.

2. Load the recommended media and ribbon for your application and adjust the

Media Sensor Position.

3. Activate the PAUSE Key Self Test, print a few labels, and press the PAUSE key to

stop printing.

4. Observe the print quality of the test labels. If it is satisfactory, complete the

process by turning the AC Power OFF. Otherwise, continue to Step II.

This procedure is continued on the next page...

44868L Page 5-9

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 118 119

No comments

Zebra Stripe Technical Information Page 48