Zebra Stripe Technical Information download pdf (Page 28)

Service Diagnostics Tests

If a jumper is installed between test points TP1 and TP2 on the main logic board

when the power is turned ON, the printer will repeatedly perform the following

series of tests. TP1 and TP2 are located in the upper right area of the Main Logic

Board.

1. PAUSE Key Test - When the PAUSE Key is pressed, the Pause Light is turned

ON.

2. FEED Key Test - When the FEED Key is pressed, the step motor and ribbon take

up motors will be activated and deactivated and the DARKEN Light will turn ON.

3. CANCEL Key Test - When the CANCEL Key is pressed, the POSITION Light

will turn ON.

4. MODE Key Test - When the MODE Key is pressed, the CALIBRATE Light

turns ON.

5. Head Sensor Test - When the head is open, the PRINTHEAD Light is turned ON.

6. Media Sensor Test - When no media is detected, the PAPER/RIBBON Light is

turned ON.

7. Ribbon Sensor Test - When no ribbon is detected, the PAPER/RIBBON Light

Flashes.

8. Take Label Sensor Test - When a label is detected, the POSITION Light is

turned ON.

9. Rewind Full Test - When the rewind spindle full sensor is activated, the

CALIBRATE Light Flashes.

Stripe Maintenance Manual: Volume 1 Printer Diagnostics

44868L Page 3-11

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 118 119

No comments

Zebra Stripe Technical Information Page 28