Zebra Stripe Technical Information download pdf (Page 65)

(If your printer is not equipped with a Dual-Tension Ribbon Supply Spindle

like the one shown in Figure 5.17, skip this section.)

In the Normal Position, the Dual-Tension Spindle provides the desired amount

of ribbon back-tension for different ribbon widths.

To put the Spindle in the Normal Position, firmly pull the Spindle End-Cap until

it clicks into place, as shown in Figure 5.17.

Low-Tension Position is used in limited applications with ribbons wider than

2.4" (60 mm) to provide lower ribbon back-tension. Low-Tension Position is

only recommended when normal tension hampers the ribbon movement.

To put the Spindle in the Low-Tension Position, firmly push the Spindle

End-Cap until it clicks into place, as shown in Figure 5.17.

Page 5-26 44868L

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 118 119

No comments

Zebra Stripe Technical Information Page 65