Zebra Stripe Technical Information download pdf (Page 71)

CAUTION: Prior to removing and replacing circuit boards and electrical

assemblies, observe proper electrostatic and electrical safety precautions.

1. Refer to the Logic Board and Control Panel drawing in Section 7. Turn the

printer OFF and remove the power cord.

2. Orient the printer with the electronics compartment facing the technician.

3. Remove the three 5mm Hex screws that mount the Electronics Compartment

Cover to the Main Frame and remove the cover.

4. Remove the Control Panel Assembly. See instructions on page 5-31.

5. Remove the Media Compartment Cover (Main Door part # 44070 in Section

7) by firmly grasping the cover and pushing it forward and out.

6. Remove the Media Sensor Assembly by removing (2) Phillips screws and

pull assembly away from the Main Frame. See instructions on page 5-30.

NOTE: See page 5-30 and perform the Media Sensor Assembly Removal Procedure before

removing the Main Logic Board.

7. Note the positions of and unplug all Ribbon connectors and small wire

connectors, Head, Control Panel, Tension Motor, Take Label Sensors and

Full Roll Sensor cables connected to the Main Logic Board.

8. Remove the two 5mm Hex screws used to mount the Main Logic Board to

the Main Frame. For newer printers, you must also remove the two standoffs

(Part A on the schematic in Section 7) and the flat jumper (44537).

9. Rotate the Head Open Flag out of the way.

10. Carefully grasping both sides of the Main Logic Board, pull the board

straight up from the Power Supply connector and out of the unit.

1. Carefully align connector J9 at the bottom of the Main Logic Board with the

mating Power Supply connector.

2. Push the Main Logic Board straight down until connector J9 has seated

completely onto the power supply.

3. Reinstall the two mounting screws and reconnect all cables and connectors.

4. Reinstall Media Sensor Assembly, Front Control Panel Assembly, Rear

Cover and Main Door.

Note: When you replace a Main Logic Board on a Stripe with the Cutter Option, you

must remove the jumper between pins 4 and 5.

Page 5-32 44868L

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 118 119

No comments

Zebra Stripe Technical Information Page 71