Zebra Stripe Technical Information Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
FEED Key and PAUSE Key
Pressing these two keys at the same time, while turning the Power ON,
temporarily resets the Printer Configuration to the Factory Default values. These
values will remain active until Power is turned OFF. If the Factory Default
conditions are to be used on a permanent basis, save them by pressing the
MODE Key four (4) times - MODE Lights cycle ON then OFF. Figure 3.5
indicates which printer function controls each of the configuration parameters.
NOTE: A Media Calibration procedure must be performed after Factory Default
values are saved!
Parameter Controlled By
Darkness Front Panel Adjustment or ZPL
Tear Off Adjust Front Panel Adjustment
Web Sensor Front Panel Calibrate or ZPL
Media Sensor Front Panel Calibrate or ZPL
Ribbon Sensor Front Panel Calibrate or ZPL
Label Length Front Panel Calibrate or ZPL
Print Mode ZPL Controlled
Media Type Front Panel Calibrate or ZPL
Print Method Front Panel Calibrate or ZPL
Baud DIP Switches
Data Bits DIP Switches
Parity DIP Switches
Handshake DIP Switches
Protocol DIP Switches
Delimiter ZPL Controlled
Format Prefix ZPL Controlled
Command Prefix ZPL Controlled
Network ID ZPL Controlled
Modes Enabled ZPL Controlled
Modes Disabled ZPL Controlled
Resolution ZPL Controlled
Label Top Front Panel Adjustment or ZPL
Socket 1 ID EPROM
Socket 2 ID EPROM
Firmware Firmware Controlled
Configuration Firmware Controlled
Memory Functioning Memory
Battery RAM ZPL Controlled
Media Power Up ZPL Controlled
Media Head Close ZPL Controlled
Figure 3.5 Configuration Parameter Controls
Stripe Maintenance Manual: Volume 1 Printer Diagnostics
44868L Page 3-5
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 118 119

Comments to this Manuals

No comments