Zebra Stripe Technical Information download pdf (Page 43)

To determine the position and length of the label or ticket stock, the Media

Sensor senses either the “web” between labels or a hole or notch in the print

media.

When using label stock that has a web between labels, you can position the

Media Sensor anywhere across the inside 50% of the web. The factory-set

position should be sufficient for any width label, so little or no repositioning

should be required when using media with a web.

For notched media, it may be necessary to reposition the Upper Media Sensor.

See Figure 5.2 and follow the procedure below.

1. With the Printhead OPEN, look through the right side of the print

mechanism and locate the Media Sensor Adjustment Lever.

2. Look through the front of the print mechanism and reposition the Adjustment

Lever until the top of the lever is in line with the notch in the media. CLOSE

the printhead by moving the Head Open Lever to the CLOSED position.

NOTE: Position the Media Sensor directly over the hole or notch when using tag stock.

Position the Media Sensor Adjustment Lever so that rounded corners of the

label are NOT detected or else tracking errors may result. For best results,

position the sensor lever at one of the molded-in position indicators.

Page 5-4 44868L

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 118 119

No comments

Zebra Stripe Technical Information Page 43