Zebra Stripe Technical Information download pdf (Page 57)

11. Push the Ribbon Cable “G” into the Print Element Assembly “A” connector,

making sure that it is fully seated. (Failure to fully seat the connector may

result in damage to the Printhead Element Assembly on power-up.)

12. Loosely install the Position Locking screws “H” and adjust the position of

the Head Mounting Bracket “B” until the pencil marks from step 3 are

aligned, then tighten the screws.

13. Reinstall the Ground Strap, Screw, and Star Washer removed in step 5.

14. Loosely install the Strip Plate “F”.

NOTE: Use a cotton swab moistened with Zebra-recommended cleaning solution (part

# 01426) to clean the element surface before printing.

15. Load Media and Ribbon and turn the printer power ON.

16. Adjust the printhead voltage. See “Printhead Voltage Adjustment”, page

5-19.

17. Turn the Power OFF and, while pressing the PAUSE Key, turn the Power

back ON to initialize the “Head Alignment” test, or download a format you

wish to use and check the print quality.

18. If satisfied with the printing results, tighten the “D” Printhead Support

Bracket screws while the head is latched. If further adjustments are

necessary, proceed with the “Type C Print Quality Adjustments” on the next

page, beginning with Step 5.

NOTE: Proceed only after you have verified that the proper media and ribbon

combination is being used, the “DARKNESS” setting is correct and the head

pressure is properly balanced. See “Printhead Pressure Adjustment”, page 5-20.

1. Remove the ribbon if installed.

2. Close and latch the printhead then use a pencil to outline the wings of the

Head Bracket “C” on the Head Mounting Bracket “B”. See Figures 5.11

and 5.12. These marks will be used to identify the original position and

gauge movement of the Head Mounting Bracket “B” during adjustment.

3. Load Media and Ribbon if used.

Page 5-18 44868L

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 118 119

No comments

Zebra Stripe Technical Information Page 57