Zebra Stripe Technical Information download pdf (Page 21)

“Darkness” value specified on the Configuration Printout.

The resulting numeric value (0 to 30) is the best darkness value for that specific

Media/Ribbon combination.

The plus or minus value selected can be entered while performing a Media

Darkness Adjustment. Enter the PLUS value by pressing the UP (FEED) Key, or

enter the MINUS value by pressing the DOWN (CANCEL) Key the appropriate

number of times. Refer to the user’s guide for more information.

Optionally, the required Darkness adjustment value can be programmed into the

ZPL II formats sent to the printer.

MODE Key Self Test

This Self Test places the printer in a

Communications Diagnostics Mode.

Press the MODE Key while turning

the AC power switch ON, then send

a label format to the printer. In this

mode, the printer prints the ASCII

characters and their corresponding

hexadecimal values for any data

received from the host computer.

See the example in Figure 3.4.

NOTE: Turn the Printer Power OFF to

exit this Self Test.

FEED, PAUSE, and CANCEL Keys

If these three keys are pressed at the same time and the Power is turned ON, the

printer enters the Media Sensor and Ribbon Sensor Adjustment Mode. See

Section 5 for these adjustments.

Figure 3.4 MODE Key Self Test Printout

Printer Diagnostics Stripe Maintenance Manual: Volume 1

Page 3-4 44868L

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 118 119

No comments

Zebra Stripe Technical Information Page 21