Zebra Stripe Technical Information download pdf (Page 33)

I. Remove the Cutter Module from the printer.

1. Turn the printer’s AC power OFF.

2. Remove the Label Catch Tray by lifting it up and away from the front of the Cutter Module.

3. Raise the printer’s Media Access Door and lower the printer’s Front Door. Refer to Figure 4.2.

4. Refer to Figure 4.3. Gently pull straight down on the Cutter Cable Connector to remove it from

the mating socket on the Cutter Module.

5. Turn the Cutter Mounting Screw (by hand or with a screwdriver) in a counter-clockwise direction

until it is loose.

6. Refer to Figure 4.4. Hold the Cutter Module as shown. Apply gentle upward pressure to the left

and right ends while raising the Cutter Module up and away from the Mounting Posts. If

necessary, rock the Module side-to-side to loosen it.

This procedure is continued on the next page.

Page 4-4 44868L

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 118 119

No comments

Zebra Stripe Technical Information Page 33