Zebra 105SL Specifications download pdf (Page 73)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 3-3

TROUBLESHOOTING SECTION 3

35,17(56(/)7(676

,QWURGXFWLRQ

These self tests, illustrated on the following pages, produce sample labels and provide

specific information that helps determine the operating conditions for the printer.

Each self test is enabled by holding in a specific front panel key or keys while turning the

power switch ON. Keep the key(s) pressed until the front panel LEDs turn ON.

When the Power-On Self Test (POST) is completed, the selected printer self test starts

automatically.

&RQVLGHUDWLRQV

When performing self tests, all data interface cables should be disconnected from the printer.

Full-width media should be used when performing these tests. If your media is not wide

enough, the test labels may print on the label and the platen roller, or in the case of narrow

media, not on the label at all. To prevent this from happening, check the configuration

parameter “Setting the Print Width”, and ensure it is correct for the media you are using.

Labels less than full-width in size lose printing on the right side. Label length determines the

amount of print starting at the top of the label. If your media is too short, the test label

continues on the next label.

When canceling a self test prior to its actual completion, always turn the printer power OFF

and then back ON to reset the printer.

If the printer is in Peel-Off mode while these self tests are performed, the operator must

remove the labels manually as they become available.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 245 246

No comments

Zebra 105SL Specifications Page 73