Zebra 105SL Specifications download pdf (Page 56)

Page 2-34 105SL Maintenance Manual 32056L Rev. 2 12/4/01

SECTION 2 OPERATION OVERVIEW

1. Press the right oval key to select “YES”. If your printer is set to require a password, you

are prompted to enter the password.

2. Enter the password then press the NEXT key.

3. The display shows “INITIALIZE CARD?” Press the right oval key to select “YES”. The

display shows “ARE YOU SURE?”

4. Press the right oval key to select “YES” and begin the initialization, or, press the left

oval key to select “NO” to cancel the request and return to the “INITIALIZE CARD”

prompt.

5. Press the SETUP/EXIT key followed by the NEXT key once you have selected YES.

If initialization is still in process, the display flashes back and forth between the two phrases

“CHECKING B: MEMORY” and “PRINTER IDLE.”

When initialization is complete, the printer automatically exits the configuration mode and the

display shows “PRINTER READY”.

NOTE: Depending on the amount of memory in the memory card, initialization

may take up to five minutes to complete.

,QLWLDOL]H)ODVK0HPRU\

This selection initializes the flash memory.

1. Press the right oval key to select “YES”. If your printer is set to require a password, you

are prompted to enter the password. Enter the password using (–) and (+) switches

and then press the NEXT key.

2. The display shows “INITIALIZE FLASH MEM?” Press the right oval key “YES”. The

display shows “ARE YOU SURE?”

$5(<28685(

12 <(6

CAUTION:

Perform this operation only when it is necessary to erase all

previously stored information in the optional flash memory.

If you do not want to erase all stored information, press the NEXT key

to bypass the operation.

,1,7)/$6+0(0

<(6

$5(<28685(

12 <(6

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 245 246

No comments

Zebra 105SL Specifications Page 56