Page 6-2 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
,QVWDOODWLRQ
The printer must be partially disassembled in order to install the various parts provided in this
kit. Use the following procedure to install the kit.
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover. Open the printhead and remove the media and ribbon. Close
the printhead.
3. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.
NOTE: The cables to the power supply do not need to be removed.
4. For printers with configuration number 10500-0XXX-XXXX or 10500-1XXX-XXXX,
refer to RRP No. 3 on page 4-13 and remove the DC power supply.
or
For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,
refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.
5. Refer to Figure 6-2. Remove and retain the plastic plug in the lower access hole near
the bottom of the side plate.
6. Place a flat washer (2) onto one of the screws (8). Using the Allen wrench provided
with this kit, place this mounting screw through the lower access hole in the side plate
and through the idler pulley mounting slot in the printer main frame. On the electronics
side of the printer main frame, attach the idler shaft (21) to the mounting screw.
Figure 6-1. Backing Rewind Option Kit
19
8
2
1
2
3
10
5
6
11
7
2
8
3
4
Stepper Motor Pulley
(Not Included)
17
12
13
14
15
16
21
18
22
23
20
9
Comments to this Manuals