Zebra 105SL Specifications download pdf (Page 163)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-77

PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4

were made correctly. Replace the fuse and reconnect the power cord. Place the power

switch in the On (I) position.

5LEERQ7DNH8S3XOOH\5HSODFHPHQW

1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position

and disconnect the AC power cord. Disconnect the data cables.

2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.

3. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.

4. Refer to Figure 4-58 and use a screwdriver or pair of pliers and remove the E-ring.

5. Slide the ribbon take-up pulley off the shaft.

NOTE: Do not remove the spacer, flat washer, and wave washer.

6. Slide the replacement pulley onto the ribbon shaft.

WARNING:

WEAR PROTECTIVE EYE WEAR WHEN REMOVING E-RINGS, C-CLIPS,

SNAP RINGS AND SPRINGS. ALL OF THESE ARE UNDER TENSION AND

COULD FLY OFF WHILE BEING REMOVED.

Figure 4-58. Ribbon Take-up Pulley Replacement

POWER

TAKE LABEL

ERROR

CHECK RIBBON

CANCEL

FEED

PAP ER OU T

PAUSE

DATA

NEXT/SAVE

SETUP/EXIT

Ribbon Take-Up

Pulley

E-Ring

Spacer

Flat Washer

Wave Washer

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 245 246

No comments

Zebra 105SL Specifications Page 163