Zebra 105SL Specifications download pdf (Page 173)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-87

PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4

18. If you receive a Ribbon Error, check all the steps of the installation procedure. Make

sure that the sensor power connector is fully seated into the connector on the logic

board.

7DNH/DEHO6HQVRU5HSODFHPHQW

1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position

and disconnect the AC power cord. Disconnect the data cables.

2. Open the media cover.

3. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.

4. Refer to Figure 4-67 and remove the screws that secure the upper and lower take-label

sensors.

NOTE: The upper take-label sensor has green/yellow wires.

5. Insert the upper take-label sensor connector and cable through the upper hole in the

main frame.

6. Position the sensor with the window facing down. Secure the sensor to the main frame

with one screw.

NOTE: The lower take-label sensor has black/red wires.

7. Insert the lower take-label sensor connector and cable through the lower hole in the

main frame.

8. Position the sensor with the window facing up. Secure the sensor to the main frame

with one screw.

Figure 4-67. Take-Label Sensors

Screw

Lower Sensor

Screw

Upper Sensor

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 245 246

No comments

Zebra 105SL Specifications Page 173