Zebra 105SL Specifications download pdf (Page 48)

Page 2-26 105SL Maintenance Manual 32056L Rev. 2 12/4/01

SECTION 2 OPERATION OVERVIEW

11. Press the (+) key to continue. The printer performs the second part of the calibration

process and the front panel LCD shows:

The media sensor determines a new value based on the presence of media and backing and

determines the label length. The ribbon sensor determines a new value based on the

presence of ribbon.

Once media stops feeding, the calibration process is complete!

12. Press the SETUP/EXIT key to leave the programming mode. When asked SAVE

CHANGES PERMANENT, press NEXT/SAVE to save permanently. The front panel

LCD shows:

&RQILJXUDWLRQ

After you have installed the media and ribbon and the POST (Power-On Self Test) is

complete, the front panel display shows “PRINTER READY.” You may now set printer

parameters for your application using the front panel display and the five keys directly

below it.

Refer to the Zebra 105SL Printer User’s Guide for further details on configuring the printer

for your application.

If it becomes necessary to restore the initial printer defaults, see the “FEED Key and PAUSE

Key Self Test” in Section 3, Troubleshooting, of this manual.

(QWHULQJWKH6HWXS0RGH

To enter the programming mode, press the SETUP/EXIT key. Press either the NEXT/SAVE

key or PREVIOUS key to scroll to the parameter you wish to set. Throughout this process,

press the NEXT/SAVE key to continue to the next parameter, or press the PREVIOUS key to

go back to the previous parameter in the sequence.

&KDQJLQJ3DVVZRUG3URWHFWHG3DUDPHWHUV

Certain parameters are password-protected by factory default.

0(',$$1'5,%%21

&$/,%5$7(

6$9(&+$1*(6

3(50$1(17

CAUTION:

Do not change password-protected parameters unless you’re sure

you know what you’re doing! If they are set incorrectly, these

parameters could cause the printer to function in an unpredictable

way.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 245 246

No comments

Zebra 105SL Specifications Page 48