Zebra 105SL Specifications download pdf (Page 49)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 2-27

OPERATION OVERVIEW SECTION 2

The first attempt to change one of these parameters (pressing the (–) or (+) keys) requires you

to enter a four-digit password. This is done via the “ENTER PASSWORD” display. The (–) key

changes the selected digit position. The (+) key increases the selected digit value. After

entering the password, press the NEXT/SAVE key. The parameter you are trying to change is

displayed. If the password was entered correctly, you can now change the value.

The default password value is 1234. The password can be changed using the ^KP (Define

Password) ZPL II instruction.

NOTES: Once the password has been correctly entered, it need not be entered

again unless you leave and re-enter the programming mode using the

SETUP/EXIT key.

You can disable the password protection feature so that it no longer

prompts you for a password by setting the password to ØØØØ via the

^KPØ ZPL/ZPL II command. To re-enable the password-protection feature,

send the ZPL/ZPL II command ^KPx, where “x” can be any number, 1–4

digits in length, except Ø.

/HDYLQJWKH6HWXS0RGH

You can leave the setup mode at any time by pressing the SETUP/EXIT key. The SAVE

CHANGES display appears. There are five choices, described below. Press the (+) or (–)

key to display the sequence of choices. When your choice is displayed on the LCD, press

the NEXT/SAVE key to save settings.

PERMANENT: saves the current settings. Values are stored in the printer even when power

is turned OFF.

TEMPORARY: saves the current settings until changed again or until power is turned off.

CANCEL: cancels all setting changes made since entering the programming mode except

the darkness and tear-off settings, if they were changed.

LOAD DEFAULTS: loads factory default settings. Refer to the User’s Guide for default

values.

NOTE: If you load factory default settings, you may have to perform a media and

ribbon sensor calibration.

LOAD LAST SAVE: reloads the settings made during the last permanent save.

6(77,1*35,173$5$0(7(56

6HWWLQJ'DUNQHVV

Darkness, also known as burn duration, settings are dependent upon a variety of factors,

including ribbon type, media and the condition of the printhead. You may adjust the

darkness for consistent high-quality printing.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 245 246

No comments

Zebra 105SL Specifications Page 49