Zebra 105SL Specifications download pdf (Page 233)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-19

OPTION KITS SECTION 6

4. Insert the ribbon cable and PrintServer II through the mounting slot.

NOTE: Figure 6-15 illustrates 105SL printers with configuration numbers

10500-0

XXX-XXXX and 10500-1XXX-XXXX. Figure 6-16 illustrates 105SL

printers with configuration numbers 10500-2XXX-XXXX and

10500-3XXX-XXXX.

5. Fold the cable and the ferrite bead back over the mounting bracket as shown in

Figure 6-15 or Figure 6-16. Connect the ribbon cable connector into the keyed

Interface data cable connector on the main logic board. Use connector J4 on printers

with configuration numbers 10500-0XXX-XXXX and 10500-1XXX-XXXX. Use

connector P21 on printers with configuration numbers 10500-2XXX-XXXX and

10500-3XXX-XXXX.

6. Fasten the PrintServer II interface board in place with the cover plate screws removed

in step 2.

7. Check all small cable connectors along the back of the main logic board for secure

connection. Reinstall the electronics cover.

NOTE: This kit includes a label printed with the Ethernet MAC hardware address

for the PrintServer II.

8. Remove the backing from the label and affix it to the back of the printer.

9. Reconnect the power cord and the data cables to the printer.

10. Reconnect the power cord to the power source. Place the power switch in the On (I)

position.

11. Consult with your System Administrator before configuring the PrintServer II for your

network!

Figure 6-14. Rear Panel

AC Power

On/Off Switch

AC Power

Cable Connection

Parallel

Interface

Connector

Note:

Depending on configuration,

the Serial Interface may be a

DB-25 or a DB-9 connector.

Serial

Interface

Connector

Allen Screws

and Plate

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 245 246

Comments to this Manuals

No comments

Zebra 105SL Specifications Page 233

Comments to this Manuals

Related products and manuals for Label printers Zebra 105SL