Zebra 105SL Specifications download pdf (Page 149)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-63

PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4

8. Position the upper drive arm out from the cutter frame so its flat surface is flush with the

end of the rotary cutter blade shaft.

NOTE: Overtightening the screw can damage the drive arm and strip the threads.

9. Use a 5/16

″ Allen socket on a torque wrench and tighten the screw until the slot closes

or until a torque of 100 inch-pounds (11.3 Nm) is achieved.

10. Test the cutter alignment by feeding maximum width label stock through the printer and

ensuring that complete cutting of the label occurs. If necessary, repeat the procedure to

achieve complete cutting of the labels.

11. With a felt tip pen, draw a line across the outer face of the upper drive arm and the end

of the cutter blade shaft. If cutter operation problems occur, this mark shows if the

alignment of the clamp and the cutter blade shaft has changed.

&XWWHU0RWRU5HSODFHPHQW

Removing the Cutter Motor

1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position

and disconnect the AC power cord. Disconnect the data cables.

2. Refer to RRP No. 2 on page 4-12 and remove the electronics cover.

3. Open the media cover.

4. For printers with configuration number 10500-0XXX-XXXX or 10500-1XXX-XXXX,

refer to RRP No. 3 on page 4-13 and remove the DC power supply.

For printers with configuration number 10500-2XXX-XXXX or 10500-3XXX-XXXX,

refer to RRP No. 5 on page 4-16 and remove the AC/DC power supply.

Figure 4-46. Mechanical Assembly Positioning

Rotary Cutter Blade

Upper Cutter Bracket

Mounting Screw

Media Guide

0.100

(2.5 mm)



Ensure the Top of the Tear-Off

Bar is Positioned Above or

Level With the Top of the

Rear Cutter Blade

Tear-Off

Bar

Clearance of 0.030 (0.75 mm)

Minimum Between the Rear

Cutter Blade and Tear-off Bar



Screws (4)

Control Position

of Cutter Module &

Squareness to Media

Rear Cutter

Blade

Relative position of the Rotary Cutter Blade when the Drive Link Assembly

is stopped by the Optical Sensor, when the Power is on in Cutter Mode

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 245 246

Comments to this Manuals

No comments

Zebra 105SL Specifications Page 149

Comments to this Manuals

Related products and manuals for Label printers Zebra 105SL