Zebra 105SL Specifications download pdf (Page 122)

Page 4-36 105SL Maintenance Manual 32056L Rev. 2 12/4/01

SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE

2. Refer to Figure 4-24 and locate the upper media sensor.

3. Carefully loosen, but do not remove, the screw at the top of the sensor.

NOTE: When using label stock that has a web between labels, position the upper

media sensor anywhere along the web, except where the rounded corners

of the label are detected. When using tag stock, position the upper sensor

directly over the hole or notch.

4. Slide the upper sensor along the slot to the desired position.

5. Tighten the screw to secure the sensor.

Use the following procedure to adjust the lower transmissive media sensor:

1. Refer to Figure 4-25 and locate the lower media sensor assembly under the rear idler

roller.

2. Position the sensor by sliding it in its slot, so that the two infrared emitters are directly

centered under the upper sensor.

3. Gently pull wires out as required. Wires should have a little slack.

NOTE: If moving the sensor results in a large loop of wires, dress the wires so

that they will not contact any moving parts, media, or ribbon.

Figure 4-24. Upper Transmissive Media Sensor Position Adjustment

Figure 4-25. Lower Transmissive Media Sensor Position Adjustment

Upper Media Sensor

Adjustment Screw

Lower Media Sensor

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 245 246

No comments

Zebra 105SL Specifications Page 122