Zebra 105SL Specifications download pdf (Page 36)

Page 2-14 105SL Maintenance Manual 32056L Rev. 2 12/4/01

SECTION 2 OPERATION OVERVIEW

3HHO0RGH

NOTE: Liner rewind or media rewind option required.

Refer to Figure 2-15.

1. Remove the rewind plate from the front of the printer, if installed. Store it on the two

mounting screws on the inside of the front panel.

2. Open the printhead.

3. Slide the media guide and media supply guide as far from the printer frame as possible.

4. Load media as shown.

5. When loading media, allow approximately 36″ (915 mm) of media to extend past the

tear-off/peel-off bar. Remove all labels from this portion to create a leader.

6. Remove the hook from the rewind spindle. If you are using a core, for rewind option

only, slide it onto the rewind spindle until it is flush against the guide plate.

7. Wind the label backing around either the 3″ (76 mm) core or the rewind spindle and

reinstall the hook.

8. Slide in the media guide and media supply guide so they just touch, but do not restrict,

the edge of the roll.

Before closing the printhead, make sure:

• The media is positioned against the inside guides.

• The media is taut and parallel with the wound backing and the pathway when wound

onto the rewind spindle/core.

9. Close the printhead.

To discard the label backing from the rewind spindle, refer to “Removing the Label Backing

Material” on page 2-19.

Figure 2-14. Roll Media Loading Tear-Off Mode

Open

Printhead lever

Media

supply

guide

Med

Media

guide

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 245 246

No comments

Zebra 105SL Specifications Page 36