Zebra 105SL Specifications download pdf (Page 168)

Page 4-82 105SL Maintenance Manual 32056L Rev. 2 12/4/01

SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE

15. With the printhead lever facing down, slide it onto the shaft far enough to compress the

wave washer.

NOTE: The retaining screw screws through the handle into the shaft.

16. Tighten the retaining screw so it threads into the pivot shaft.

17. Check the orientation and operation of the printhead lever, toggle, and head open flag.

18. Reinstall the electronics cover.

19. Open the printhead and reinstall media and ribbon. Close the printhead.

20. Slide the toggle to the middle of the media, and refer to “Printhead Pressure” on

page 4-30 to adjust the toggle.

21. Close the media cover.

22. Reconnect the data cables and the power cord.

23. Reconnect the power cable to the power source. Place the power switch in the On (I)

position.

24. If you get a “head open” error, check to make sure the flag, the toggle, and handle are

oriented the same way. They point down when the toggle assembly holds the printhead

closed. Make sure the flag is in the flag slot.

5HZLQG3ODWH5HSODFHPHQW

1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position

and disconnect the AC power cord. Disconnect the data cables.

2. Open the media cover.

3. Open the printhead and remove the media and ribbon. Close the printhead.

4. Refer to Figure 4-62 and carefully slide the rewind plate out of the slots in the printhead

mechanism and away from the printer.

5. Engage the top lip and hook plate of the replacement rewind plate into the two

mounting slots.

6. Slide the plate in as far as it can go.

7. Open the printhead and reinstall media and ribbon. Close the printhead. Close the

media cover.

8. Reconnect the data cables and the power cord.

9. Reconnect the power cable to the power source. Place the power switch in the On (I)

position.

10. Run test labels and check to see if the media telescopes on the rewind spindle. If it

does, refer to “Media Tracking Adjustment” on page 4-37 and adjust the hook plate on

the rewind plate.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 245 246

No comments

Zebra 105SL Specifications Page 168