32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-21
OPTION KITS SECTION 6
5. Reconnect the power cord to the power source. Place the power switch in the On (I)
position.
6. The status indicator flashes orange during the POST (Power-On Self Test) phase and
changes to green when stabilized.
NOTE: A 4
″ wide by 6″ long label is recommended for printing the configuration
label. If the label is smaller, some information may print outside the label
area.
7. Press the test button located on the back of the ZebraNet PrintServer II. A configuration
label prints.
8. Check the label to see if the printer is configured for external PrintServer applications. If
not, enter Configuration mode and configure for external Printserver applications.
Figure 6-16. Internal PrintServer ll Installation (Printer Configurations
10500-2XXX-XXXX and 10500-3XXX-XXXX)
Ferrite
Bead
Ribbon Cable
Ferrite
Bead
Data Cable
Connector
Ribbon Cable
Comments to this Manuals