Zebra XiIII Series User Manual download pdf (Page 54)

46 Zebra XiIII-Series User’s Guide

Press Display Shows Action/Explanation

PRINT WIDTH

Setting Print Width: Press the RIGHT BLACK OVAL key to

increase the value, press the LEFT BLACK OVAL key to

decrease the value. To change the unit of measurement, press

the LEFT BLACK OVAL key until the unit of measurement is

active, then press the RIGHT BLACK OVAL key to toggle to a

different unit of measure (mm, inches, or dots).

Default; Range: The default and range of acceptable values

vary depending on what printer you have. Refer to “Printing

Specifications” on page 90 for further information about the

ranges available for your model. Print width determines the

printable area across the width of the label.

NOTE: The printer does not accept any value larger than the

maximum print width listed on page 90.

MAXIMUM LENGTH

Setting Maximum Length: Press the LEFT BLACK OVAL key to

decrease the value, press the RIGHT BLACK OVAL key to

increase the value.

Default; Range: The default and range of acceptable values

vary depending on your printer’s configuration. Values are

adjustable in 1" (25.4 mm) increments.

Maximum length is used in conjunction with the calibration

procedure. The value of this setting is the maximum label length

that is used during the media portion of the calibration process.

Only a few labels are required to set media sensors. Always set

the value that is at least 1" longer than the longest label to be

used on the printer.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

No comments

Zebra XiIII Series User Manual Page 54