Zebra XiIII Series User Manual download pdf (Page 86)

78 Zebra XiIII-Series User’s Guide

3ULQW4XDOLW\3UREOHPV

*HQHUDO3ULQW4XDOLW\,VVXHV

*UD\OLQHVRQEODQNODEHOVZLWKQRFRQVLVWHQWSDWWHUQ

/LJKWFRQVLVWHQWYHUWLFDOOLQHVUXQQLQJWKURXJKDOORIWKHODEHOV

,QWHUPLWWHQWFUHDVHVRQWKHOHIWDQGULJKWHGJHVRIWKHODEHOV

Problem Solution

You are using an incorrect media and ribbon

combination for your application.

Consult your authorized Zebra reseller/distributor for

information and advice.

The printer is set at the incorrect print speed. For optimal print quality, set the print speed to the lowest

possible setting via ZPL II, the driver, or the software.

The printer is set at the incorrect darkness

level.

For optimal print quality, set the darkness to the lowest

possible setting via the front panel, the driver, or the

software.

The printhead is dirty. Clean the printhead according to the instructions on

page 64.

There is light printing (or no printing) on the

left or right side of the label or the printed

image is not sharp.

The toggle pressure needs to be adjusted. Follow the

printhead pressure adjustment instructions on page 74.

Problem Solution

The printhead is dirty. Clean the printhead according to the instructions on

page 64.

Problem Solution

The printhead or platen roller is dirty. Clean the printhead, platen roller, or both according to the

instructions on page 64.

Problem Solution

There is too much toggle pressure on the

printhead.

Reduce the toggle pressure. See “Printhead Pressure

Adjustment” on page 74.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 115 116

No comments

Zebra XiIII Series User Manual Page 86