Zebra XiIII Series User Manual download pdf (Page 33)

Zebra XiIII-Series User’s Guide 25

)URQW3DQHO.H\V

Key Function

Starts and stops the printing process.

• If the printer is not printing: no printing can occur.

• If the printer is printing: printing stops once the current label is complete.

Press to remove error messages from the display.

NOTE: Pause mode can also be activated via ZPL II (~PP, ^PP).

Forces the printer to feed one blank label each time the key is pressed.

• Printer not printing: one blank label immediately feeds.

• Printing: one blank label feeds after the current batch of labels is complete.

NOTE: Equivalent to the Slew to Home Position (~PH, ^PH) ZPL II instruction.

When in the pause mode, this key cancels print jobs.

• Print job in queue: press once for each print job to be deleted.

• Press and hold for several seconds to cancel all print jobs in the printer’s

memory. The DATA light turns off.

When in the pause mode, this key calibrates the printer for:

• Media length.

• Media type (continuous or non-continuous).

• Print mode (direct thermal or thermal transfer).

• Sensor values.

NOTE: The keys below are used only when configuring the printer. Specific uses of these keys

are explained in “Configuration”, beginning on page 41.

• Scrolls back to the previous parameter.

• Press and hold to quickly go backward through parameter sets.

• Scrolls forward to the next parameter. (Saves any changes you’ve made in the

configuration and calibration sequence.)

• Press and hold to quickly advance through parameter sets.

Enters and exits the configuration mode.

These keys change the parameter values. They are used in different ways

depending on the parameter displayed. Common uses are: to increase/decrease a

value; answer “yes” or “no”; indicate “on” or “off”; scroll through several choices;

input the password; or set up the printer for a firmware download.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 115 116

No comments

Zebra XiIII Series User Manual Page 33