Zebra XiIII Series User Manual download pdf (Page 82)

74 Zebra XiIII-Series User’s Guide

3ULQWKHDG3UHVVXUH$GMXVWPHQW

This adjustment may be necessary if printing is too light on one side or if

thick media is used. Refer to Figure 32.

1. Perform the toggle positioning procedure. If the problem is solved,

you may stop here; otherwise, continue with the rest of this procedure.

2. Print some labels at 2.4"/61 mm per second by running the PAUSE

Key Self Test (see page 83).

3. While printing labels, lower the darkness setting until a gray level of

printing is seen.

4. Loosen the knurled (upper) locking nuts at the top of the toggle

assembly/assemblies.

5. Increase or decrease spring pressure using the knurled (lower)

adjusting nuts on the shafts of the toggle until the left and right edges

of printed area are equally dark.

NOTE: Printhead life can be maximized by using the lowest pressure that

produces the desired print quality.

6. Increase darkness to the optimum level for the media being used.

7. Retighten locking nuts.

0HGLD6HQVRU3RVLWLRQ$GMXVWPHQW

See “Positioning the Media Sensors” on page 10.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 115 116

No comments

Zebra XiIII Series User Manual Page 82