Zebra XiIII Series User Manual download pdf (Page 36)

28 Zebra XiIII-Series User’s Guide

3HHO2II0RGH

Refer to Figure 17.

1. Remove the rewind plate from the front of the printer (if installed).

Store it on the two mounting screws on the inside of the front panel.

2. Open the printhead.

3. Slide the media guide and media supply guide as far from the printer

frame as possible. Flip down the media supply guide.

4. Load media as shown.

5. When loading media, allow approximately 36" (915 mm) of media to

extend past the tear-off/peel-off bar. Remove all labels from this

portion to create a leader.

6. Remove the hook from the rewind spindle. If you are using a core,

slide it onto the rewind spindle until it is flush against the guide plate.

7. Wind the label backing around either the 3" (76 mm) core or the

rewind spindle and reinstall the hook.

8. Flip up the media supply guide. Slide in the media guide and media

supply guide so they just touch, but don’t restrict, the edge of the roll.

Before closing the printhead, make sure:

• The media is positioned against the inside guides.

• The media is taut and parallel with itself and the pathway when wound

onto the rewind spindle/core.

9. Close the printhead.

10. To discard the label backing from the rewind spindle, refer to

“Removing the Label Backing Material” on page 37.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 115 116

No comments

Zebra XiIII Series User Manual Page 36