Zebra XiIII Series User Manual download pdf (Page 89)

Zebra XiIII-Series User’s Guide 81

3ULQWHU'LDJQRVWLFV

3RZHU2Q6HOI7HVW

A limited Power-On Self Test (POST) is performed automatically each

time the printer is turned on (additional self tests can be performed by

pressing the CANCEL and CALIBRATE keys when you turn the printer

on). During either test sequence, the front panel lights and liquid crystal

display (LCD) monitor the progress of the POST. If the printer fails any of

these tests, the word “FAILED” is added to the display. If this occurs,

notify an authorized Zebra reseller.

$GGLWLRQDO3ULQWHU6HOI7HVWV

These self tests produce sample printouts and provide specific information

that help determine the operating conditions for the printer.

Each self test is enabled by pressing a specific front panel key or

combination of keys while turning the POWER switch on. Keep the

key(s) depressed until the DATA light turns off. When the power-on self

test is complete, the selected self test starts automatically.

NOTE: When performing self tests, avoid sending a label format to the

printer. In the case of a remote host, disconnect all data interface

cables from the printer.

When canceling a self test prior to its actual completion, always

turn the printer power off and then back on to reset the printer.

When performing these self tests while in the peel-off mode, you

must remove the labels as they become available.

If your media is not wide enough or long enough, unexpected

and/or undesired results may occur. Make sure that your print

width is set correctly for the media you are using before you run

any self tests, otherwise the test may print out on the platen roller.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 115 116

No comments

Zebra XiIII Series User Manual Page 89