Zebra XiIII Series User Manual download pdf (Page 65)

Zebra XiIII-Series User’s Guide 57

Press Display Shows Action/Explanation

HEAD TEST COUNT

Setting the Head Test Count: Press the LEFT BLACK OVAL

key to move the cursor, press the RIGHT BLACK OVAL key to

change the value of the digit.

Default: 0000 (disables the test)

Range: 0000 to 9999

The printer periodically performs a test of the printhead

functionality, called a “printhead test” or “head test.” This

parameter establishes how many labels are printed between

these internal tests.

HEAD RESISTOR

Setting the Head Resistor Value: Press the LEFT BLACK

OVAL key to move the cursor, press the RIGHT BLACK OVAL key

to increase the value of the digit.

CAUTION: This parameter should only be changed by qualified

personnel!

Initial Value: Factory-set to match the printhead shipped with

your printer.

Default Value: 0500

Range: 0500 to 1175

This value has been pre-set at the factory to match the resistance

value of the printhead. It does not need to be changed unless the

printhead is replaced or the main logic board is replaced.

CAUTION: DO NOT set the value higher than that shown on the

printhead. Setting a higher value may damage the

printhead!

Before replacing a printhead, look on the printhead for the label

that shows the resistance value (ohm value).

VERIFIER PORT

Setting the Verifier Port: Press the RIGHT or LEFT BLACK

OVAL key to display other choices.

Default: Off

Selections: Off, 1 VER-RPRNT, 2 VER-THRUPUT

The auxiliary port is used to determine how the printer reacts to

the on-line verifier. There are currently three operating conditions

for this port:

• Off: The verifier port is off.

• 1 VER-RPRNT ERR: Label reprinted if verifier detects an error.

If a bar code is near the upper edge of the label, the label is fed

out far enough to be verified and then backfed to allow the next

label to be printed and verified.

• 2 VER-THRUPUT: Allows greatest throughput but may not

indicate a verification error immediately upon detection. May

print from one to three labels before an error is recognized and

printing stops.

For more information on the operation of the optional verifier, refer

to the documentation provided with that option.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 115 116

Comments to this Manuals

No comments

Zebra XiIII Series User Manual Page 65

Comments to this Manuals

Related products and manuals for Label printers Zebra XiIII Series