Zebra XiIII Series User Manual download pdf (Page 51)

Zebra XiIII-Series User’s Guide 43

/HDYLQJWKH6HWXS0RGH

You can leave the program mode at any time by pressing the SETUP/EXIT

key. The “SAVE CHANGES” display appears. There are five choices, as

described below. Pressing the LEFT

or RIGHT BLACK OVAL key

displays other choices and pressing the NEXT/SAVE key selects the

displayed choice.

• PERMANENT — Permanently saves the changes. Values are stored in

the printer even when power is turned off.

• TEMPORARY — Saves the changes until you change them again or

until power is turned off.

• CANCEL — Cancels all changes from the time you pressed the

SETUP/EXIT key except the darkness and tear-off settings (if they were

changed).

• LOAD DEFAULTS — Loads factory defaults. The factory defaults are

shown on the following pages.

NOTE: Loading factory defaults requires printer calibration.

• LOAD LAST SAVE — Loads values from the last permanent save.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

No comments

Zebra XiIII Series User Manual Page 51