Zebra XiIII Series User Manual download pdf (Page 30)

22 Zebra XiIII-Series User’s Guide

When communicating via the parallel

port (refer to Figure 14), the

previously mentioned parameters are

not considered. Refer to page 51 to

configure the communication

parameters for the printer. The values

selected must be the same as those

used by the host equipment connected

to the printer.

For serial and parallel pinout and

technical information, refer to

“Appendix” on page 93.

Figure 14

&DEOLQJ5HTXLUHPHQWV

Data cables must be fully shielded and fitted with metal or metalized

connector shells. Shielded cables and connectors are required to prevent

radiation and reception of electrical noise.

To minimize electrical noise pickup in the cable:

• Keep data cables as short as possible.

• Do not bundle the data cables tightly with the power cords.

• Do not tie the data cables to power wire conduits.

NOTE: Zebra printers comply with FCC “Rules and Regulations”,

Part 15, Subpart J, for Class A Equipment, using fully shielded

6' data cables. Use of longer cables or unshielded cables may

increase radiated emissions above the Class A limits.

RS-422 and RS-485 applications should use twisted shielded

pairs as recommended in the Appendix of the TIA/EIA.-485

Specification.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 115 116

No comments

Zebra XiIII Series User Manual Page 30