Zebra XiIII Series User Manual download pdf (Page 50)

42 Zebra XiIII-Series User’s Guide

&KDQJLQJ3DVVZRUG3URWHFWHG3DUDPHWHUV

Certain parameters are password-protected by factory default.

CAUTION: Do not change password-protected parameters unless

you are sure you know what you are doing! If the

parameters are set incorrectly, they could cause the

printer to function in an unpredictable way.

The first attempt to change one of these parameters (pressing one of the

BLACK OVAL keys) requires you to enter a four-digit password. This is

done via the “ENTER PASSWORD” display. The LEFT BLACK OVAL

key changes the selected digit position; the RIGHT BLACK OVAL key

increases the selected digit value. After entering the password, press the

NEXT/SAVE key. The parameter you wish to change is displayed. If the

password was entered correctly, you can now change the value.

The default password value is 1234. The password can be changed using

the ^KP (Define Password) ZPL II instruction or through ZebraLink



WebView (optional ZebraNet

PrintServer II required).

NOTE: Once the password has been entered correctly, it does not have to

be entered again unless you leave and re-enter the programming

mode using the SETUP/EXIT key, or if you power the printer

down and then re-enter the programming mode.

You can disable the password protection feature so that it no

longer prompts you for a password by setting the password to

ØØØØ via the ^KPØ ZPL/ZPL II command. To re-enable the

password-protection feature, send the ZPL/ZPL II command

^KPx, where “x” can be any number, one to four digits in length,

except Ø.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 115 116

No comments

Zebra XiIII Series User Manual Page 50