Zebra XiIII Series User Manual download pdf (Page 38)

30 Zebra XiIII-Series User’s Guide

5HZLQG0RGHIRU3ULQWHUV:LWKRXWWKH&XWWHU2SWLRQ

NOTE: Rewind option required.

Refer to Figure 18.

1. Remove the rewind plate from its storage location in front of the print

mechanism inside the media compartment.

2. Invert the rewind plate so that the lip on the attached hook plate points

down.

3. Insert the hook plate lip a short distance (½"/13 mm) into the lower

opening in the side plate.

4. Align the upper end of the rewind plate with the corresponding

opening in the side plate. Slide in the rewind plate so that it stops

against the printer’s main frame.

5. Open the printhead.

6. Slide the media guide and media supply guide as far from the printer

frame as possible. Flip down the media supply guide.

7. Load media as shown.

8. When loading media, allow approximately 36" (915 mm) of media to

extend past the printhead. Remove all labels from this portion to

create a leader.

9. Remove the hook from the rewind spindle. If you are using a core,

slide it onto the rewind spindle until it is flush against the guide plate.

10. Wind the label backing around either the 3" (76 mm) core or the

rewind spindle and reinstall the hook.

11. Flip up the media supply guide. Slide in the media guide and media

supply guide so they just touch, but don’t restrict, the edge of the roll.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 115 116

No comments

Zebra XiIII Series User Manual Page 38