If the default value for an instruction parameter suits your application,
you need not specify that parameter. However, parameters are
“position-specific.” If you want to change just the third parameter, for
example, you must indicate that it is the third parameter that you want
to change. To do so, use a comma, the ZPL II delimiter character,to
mark each parameter’s place (i.e. ^AA,,60). If you enter a parameter,
all further parameters to the right are to be defaulted, no further com-
mas are required.
HHIMPORTANTHH
Some instructions include the following abbreviation: {I.V.P. = }
This signifies the Initial Value at Power-up regardless of the value
when the printer was turned off.
NOTE: To permanently save configuration settings in the printer’s
configuration memory, you will need to send a ^JUS command at
the end of the ZPL II script. (See ^JU on page 270)
CHAPTER 2 9
ZPL II Basics
15 Undeniable Reasons To Love Tiktokpornstar tiktokpornstar
What Do You Need To Know To Be All Set To Top Pornstars Kayleigh Wanless top pornstars kayleigh Wanless