Zebra Fonts
Most Zebra printers come standard with 8 bitmapped fonts and one
scalable font. Additional downloadable bitmapped and scalable fonts
are also available.
Character size and density (how dark it appears) depends on the den-
sity of the printhead and the media used. Three different printheads
are available: 6 dots/mm, 8 dots/mm and 12 dots/mm.
Internal bitmapped fonts can be magnified from 2 to 10 times their
normal (default) size. The magnification factor is in whole numbers.
Therefore, if the normal size of a bit mapped font is 9 dots high and 5
dots wide, a magnification factor of 3 would produce a character of 27
dots high and 15 dots wide. Height and width can be magnified inde-
pendently.
Understanding Bitmapped Font Magnification Factors
The font instructions in this chapter contain parameters for entering
the height and width of printed characters. The values are always
entered in dots. When entering these values for bitmapped fonts, use
the following formula:
Base Height x Magnification Factor = Height Parameter Value. (Same
principle applies to width.)
EXAMPLE:
Base height of bitmap character is 9 dots.
Base width of bitmap character is 5 dots.
To magnify the character 3 times,
the height parameter is 27
the width parameter is 15.
NOTE: For consistent results, always use the correct parameter
values. See the specific font tables in Appendix C.
Font Selection
To use a text font, you must either use the change alphanumeric
default font instruction (^CF - explained fully in the Command Refer-
ence section, page 180) or specify an alphanumeric field instruction
(^A - explained in the Command Reference section, page 96).
12 CHAPTER 2
ZPL II Basics
15 Undeniable Reasons To Love Tiktokpornstar tiktokpornstar
What Do You Need To Know To Be All Set To Top Pornstars Kayleigh Wanless top pornstars kayleigh Wanless