Zebra XiIIIPlus User Manual download pdf (Page 46)

22 RXiIIIPlus User Guide 6/21/2004 23063L-001 Rev. 2

Printer Operation

Load the Printer

This section gives you a series of instructions to load labels and ribbon (if used). The

instructions that follow are for a standard printer in Tear-Off Mode.

Load Roll Media

Roll media feeds through the printer from the media hanger or media supply spindle.

Figure 14 identifies the components of the printer that you need to be familiar with to load roll

media.

Figure 14 • Interior Components for Media Loading

To load roll media, complete these steps:

1. Open the printhead.

2. Slide the media guide away from the printer frame. You might need to loosen the media

guide screw.

3. Put the roll of media on the media hanger or spindle. If using a media hanger, adjust the

media guide on the hanger so it just touches the media.

4. Push the label core toward the printer frame. The labels must be aligned with the label

core.

5. Feed the media under the media guide roller and under the printhead.

Caution • Be sure the printer is Off (O) if you have connected the power cable.

Printhead lever

Media guide

Media back plate

Optional media spindle

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 151 152

No comments

Zebra XiIIIPlus User Manual Page 46