Zebra XiIIIPlus User Manual download pdf (Page 70)

46 RXiIIIPlus User Guide 6/21/2004 23063L-001 Rev. 2

Front Panel Controls

Front Panel LCD

PRINT WIDTH

Setting Print Width

Print width determines the printable area across the width of the label.

To change value shown:

1. Press the left oval to move the cursor.

2. Press the right oval to increase the value of the digit.

Note • The printer does not accept any value larger than the maximum print width listed in

General Specifications on page 116.

To change the unit of measurement:

a. Press the left oval until the unit of measurement is active.

b. Press the right oval to toggle to a different unit of measure (mm, inches, or dots).

Default Range:

The default and range of acceptable values vary depending on what

printer you have. See General Specifications on page 116 for further information about the

ranges available for your model.

MAXIMUM

LENGTH

Setting Maximum Length

Maximum length is used in conjunction with the calibration procedure. The value of this

setting is the maximum label length that is used during the media portion of the calibration

process. Only a few labels are required to set media sensors. Always set the value that is at

least 1 in. (25.4 mm) longer than the longest label to be used on the printer.

• To increase the value, press the right oval.

• To decrease the value, press the left oval.

Default Range:

The default and range of acceptable values vary depending on your

printer’s configuration. Values are adjustable in 1 in. (25.4 mm) increments.

Table 5 • Printer Parameters (Sheet 3 of 15)

Parameter Action/Explanation

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 151 152

No comments

Zebra XiIIIPlus User Manual Page 70