Zebra CPCL Specifications Page 209

  • Download
  • Add to my manuals
  • Print
  • Page
    / 497
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 208
Mobile Printing Systems
CPCL Programming Manual
Section 12
Wireless
Network
Printers
pg. 12-1
WIRELESS NETWORK PRINTERS
Introduction
NOTES: The printers described in this section are no longer produced by Zebra.
If you are using a WLAN enabled QL,RW or MZ series printer, you should use the “get, set,do” parameters detailed in Section 14
rather than the LAN command detailed below.
Zebra Cameo 3N and Encore 3N Network Printers are equipped with a WLAN (Wireless Local Area
Network) card. Network printers allow wireless communication as a node within a local area network, and
its wireless capabilities allow communications from any point within the LAN’s perimeter.
The following section details commands used with Network Printers to configure various characteristics
and to interrogate the printer for its network settings.
Network Printer Safety Consideration
Caution: Use of the Network Printers will result in exposure to Radio Frequency radiation. To conform to FCC RF exposure
requirements these printers must be used only in the intended orientation and in the intended manner.
Refer to the Users Manual for the Network Printer in use for more specific safety instructions. In all
cases, avoid prolonged exposure closer than 5 cm. (2 in.) to the radiating area around this units antenna.
LAN Command
Format:
LAN { Operation } { Options }{ Operation } { Options }
The LAN command can be used to interrogate and configure the Wireless LAN (WLAN) card in a Zebra
Network Printer. The entire LAN command must be terminated by a CRLF pair (0x0D0x0A).
{Operation} is a required element. An error will be returned if an invalid operation is specified (see ‘LAN
Command Response’ for error codes). Any desired number of Operations can be entered after the LAN
command.
continued
Page view 208
1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 496 497

Comments to this Manuals

No comments