Zebra CPCL Specifications download pdf (Page 180)

100

101

Mobile Printing Systems

CPCL Programming Manual

Section 10

Advanced

Utilities

pg. 10-31

continued

! U1 S-CARD CT_ATR

Response:

CT_DATA: This command is used to send a command to the smart card. The response from the card

is returned. A command of this type has the following form:

<CT_DATA> <Length of command> <card command in ascii form>

CT_DATA Example :

! U1 S-CARD CT_DATA 10 8010000008

Description: CT_DATA: indicates the command is to go to the smart card.

10 = length of command

8010000008 = Command to go to the card in ASCII form. This command is converted to

binary and sent to the card.

CT_CLOSE: This command will power down the reader and turn off the red LED on the smart card

module. (LED is available with Cameo “SC” models only). This command should be used after

communicating to the card with the CT_DATA command.

CT_QUERY: This command is used to retrieve any buffered card response. It is to be used after

issuing a card command with the ‘QUERY’ option. This command is only available with the TDA8029

and SCR135 readers.

DEBUG-ON: Enables debug on the printer. This will cause some messages to print out as the printer

configures itself for pass-through mode. The messages printed relate to port parameters for the

internal communication port communicating with the Smartcard reader and a message will also print

out when the printer has been taken out of pass-through mode. Once in ‘pass-through’ mode, no

debug messages are printed.

{Options}

Note: {Options} must precede the {Operation}

ASCII: Data returned from the card will be converted to ASCII. Normally, data returned is in binary

form. However, with the ASCII option, returned data will be in ASCII form.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 496 497

Comments to this Manuals

No comments

Zebra CPCL Specifications Page 180

Comments to this Manuals

Related products and manuals for Print & Scan Zebra CPCL