Zebra S400 User's Guide download pdf (Page 28)

Printer Setup

Select a Data Communication Interface

79695L-001 Rev. A ZM400/ZM600 User Guide 3/27/07

Data Cables and Wireless Cards

You must supply all data cables or wireless cards for your application.

Data Cables Ethernet cables do not require shielding, but all other data cables must be fully

shielded and fitted with metal or metallized connector shells. Unshielded data cables may

increase radiated emissions above the regulated limits.

To minimize electrical noise pickup in the cable:

• Keep data cables as short as possible.

• Do not bundle the data cables tightly with the power cords.

• Do not tie the data cables to power wire conduits.

Wireless Cards For supported wireless cards, refer to the ZebraNet Wireless Print Server

and Wireless Plus Print Server User Guide. A copy of the manual is available at

http://www.zebra.com/manuals or on the user CD that came with your printer.

Connect the Printer to the Computer or Network

Table 6 shows how to connect the different types of data cables to your printer and computer.

The connectors on the back of your computer may be in different locations than on the sample

computer shown in this section. For another view of the connectors on the printer, see Figure 3

on page 8.

Caution • Ensure that the printer power is off (O) before connecting data communications

cables. Connecting a data communications cable while the power is on (

I) may damage the

printer.

Table 6 • Connecting the Printer to a Computer or Network

Interface Connection and Configuration

RS-232 Serial The baud rate, number of data and stop bits, the parity, and the

XON/XOFF or DTR control must match those of the host computer. See

Control Panel Parameters on page 61 to view or change these parameters.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 145 146

No comments

Zebra S400 User's Guide Page 28